Associate Quality Inspector (painting)
McDermott
- Batam, Kepulauan Riau
- Permanen
- kerja tetap
- Read and to understand the Project Specification, applicable Codes and Standards, Procedures and Inspection and Test Plan.
- Calibration of inspection and test instruments, using coatings inspection and test instruments.
- Enforcement and verification of work performed in accordance with specification, manufacturer recommendations and coating procedure.
- Measure ambient conditions, surface temperature and air quality requirements.
- Inspect Type of blasting equipment and tools to be used
- Inspect Type and size of blasting media.
- Inspect metal surface imperfections / defects
- Test indications of oil or water in compressed air.
- Test analyses of water-soluble ionic contamination of blasting media.
- Inspect pre-cleaning, solvent cleaning of surface, Mechanical surface preparation during pre-fabrication and onsite portable centrifugal blasting, Open air blast cleaning, Vacuum blast cleaning, Hand and power tool cleaning.
- Measure compressed air pressure.
- Inspect degree of cleanliness required.
- Measure surface profile of blast cleaned surface.
- Assess surface cleanliness of blast cleaned surface.
- Inspect coating material storage conditions.
- Inspect type of coating material to be used.
- Monitor thinning, mixing, induction time and pot life.
- Inspect type of coating application equipment, Thermal Sprayed Aluminum, Passive Fire Protection, Self-leveling compounds, Anti-skid deck coatings, Coated Hot Dip Galvanizing, Insulation and its acceptance.
- Monitor application method, type and pattern.
- Measure wet film thickness by notch gages.
- Non-destructive measurement of dry film thickness of non-magnetic coatings / non-conductive coatings applied to ferrous surface.
- Monitor re-coating and final curing schedules.
- Test discontinuities (holiday or pinholes) of coatings and linings.
- Inspection of defects on coated surface.
- Acceptable and unacceptable defects.
- To stop non-conforming work and inform the production supervisor of required corrective rework.
- Documentation of the daily inspection activities and other necessary activity as per the project requirement.
- High standard of safe working practice, quality and productivity as well as compliance with the code of business conduct.
- Under graduated Degree / Senior High School
- 5+ years Quality control or related experience in Weld, NDT,Paint, Material, Electrical, Instrumentation, Telecommunication, Equipment Inspection and ISO metric drawing reading skills